FPS 4160 4-CH AMPLIFIER

The FPS 4160 4-channel amplifier sends 120 watts RMS per channel to your front and rear pairs of full-range speakers or components. You can use this versatile amp to power four 2-ohm subs with 200 watts RMS each, or switch to 2-channel mode and drive a pair of subs with 380 watts RMS each. You can even power your front speakers with two of the amp’s channels while bridging the rear channels to drive a single sub. High-pass, low-pass, and band-pass filtering adjusts the output to match a wide variety of speakers, components, and sub combinations. And a wired remote level control for the rear cahannels give you even more control over your subs’ performance.

Description

4-channel car amplifier
120 watts RMS x 4 at 4 ohms (200 watts RMS x 4 at 2 ohms)
380 watts RMS x 2 bridged output at 4 ohms (4-ohm stable in bridged mode)
CEA-2006 compliant
variable high- and low-pass filters (50-500 Hz or 500-5K Hz)
variable band-pass filter (50-500 Hz, 500-5K Hz)
Class-AB amplifier design
thermostat-controlled, progressive-speed cooling fan
remote level control (channels 3-4)
optional High Cap outboard capacitor modules increase power efficiency
frequency response: 10-52,000 Hz
preamp inputs
4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
fuse rating: 40A x 2
Dimensions: 59 x 429 x 254 (HxWxD) mm

High-Cap Plug-in capacitors

Optional High Cap outboard capacitor modules plug directly into the amp, smoothing out any power fluctuations caused by sudden system demands, so you enjoy consistent, superb sound quality. The FPS1500 amplifier accepts two High Cap modules, one for each section of the dual power supply.

Reviews

There are no reviews yet.

Be the first to review “FPS 4160 4-CH AMPLIFIER”

You must be logged in to post a review.